IMPORTANT INFORMATION
1-2
Before servicing any equipment, make
certain it is disconnected from the
electrical power source. Never allow operation of the machine when any safety
device is malfunctioning. Never bypass safety devices.
Never insert hands or objects into basket until it has completely stopped doing so
could result in serious injury.
1.3 OPERATOR SAFETY
To ensure the safety of machine operators the following maintenance checks must be
performed daily.
1. Prior to operating the machine, verify that all warning signs are present and legible.
Missing or illegible signs must be replaced immediately. Make certain that spares are
available.
2. Check door interlock before starting operation of the machine, see safety check list.
3. Do not attempt to operate the machine if any of the flowing conditions are present.
• The door does not remain securely locked during the entire cycle.
• Excessively high water level is evident.
• Machine is not connected to a properly grounded circuit.
Do not bypass any safety devices in the machine.
Never operate the machine with a bypassed or disconnected out – of – balance
switch. Operating the machine with severe out – of – balance loads could result
in personal injury and serious equipment damage.
Do not place volatile or flammable fluids in any machine. Do not clean the
machine with volatile or flammable fluids such as acetone, lacquer thinners
enamel reducers, carbon tetrachloride, gasoline, benzene, naphtha, etc. Doing so
could result in serious personal injury and/or damage to the machine.
1.4 SAFE OPERATION ENVIRONMENT
Safe operation requires an appropriate operating environment for both the operator and the
machine. If questions regarding safety arise, contact the factory.
1.5 ENVIRONMENTAL CONDITIONS
1. Ambient Temperature
Water in the machine will freeze at temperatures of 32 ºF (0 ºC) or below. Temperatures
above 120 ºF (50 ºC) will result in more frequent motor overheating and, in some cases,
malfunction or premature damage to solid state devices that are used in the machines. Special
cooling devices may be necessary.
To Next Page
Loading...