11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
48
5. Raise platform to bed height (FIG. 48-1).
Then, lower platform to the ground (FIG.
48-2). Look for any interference be-
tween liftgate and vehicle as platform is
raised and lowered.
LOWERING PLATFORM
FIG. 48-2
RAISING PLATFORM
FIG. 48-1
NOTE: Correct any interference problems before continuing with installation.
6. If the platform lowers with a “jerking” motion,
bleed air from the hydraulic system by doing
the following. Push the control switch to the
DOWN position until you hear air escaping
into the hydraulic fl uid reservoir. Then, raise
the platform (FIG. 48-1). Repeat this step
until there is no air left in the system
and platform lowers smoothly (FIG. 48-2).
STEP 10 - REMOVE LOCKING BRACKETS & CHECK
FOR INTERFERENCE - Continued
To Next Page
Loading...
