XStream™OEMRFModule–ProductManualv5.x00[2006.02.24]
OEM Labeling Requirements
Label Warning
WARNING: The Original Equipment Manufacturer (OEM) must ensure that FCC labeling
requirements are met. This includes a clearly visible label on the outside of the final
product enclosure that displays the contents shown in the figure below.
FigureA‐01. RequiredFCCLabelforOEMproductscontaining9XStream(900MHz)OEMRFModule
Contains FCC ID: OUR9XSTREAM
The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference and (2) this device must accept any
interference received, including interference that may cause undesired operation.
FigureA‐02. RequiredFCCLabelforOEMproductscontaining24XStream(2.4GHz)OEMRFModule
Contains FCC ID: OUR-24XSTREAM
The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference and (2) this device must accept any
inter hat may cause undesired operation. ference received, including interference t
Antenna Usage
Antenna Warning
WARNING: This device has been tested with Reverse Polarity SMA connectors with the antennas
listed in Tables A.1 & A.2 of Appendix A. When integrated in OEM products, fixed
antennas require installation preventing end-users from replacing them with non-
approved antennas. Antennas not listed in the tables must be tested to comply with
FCC Section 15.203 (unique antenna connectors) and Section 15.247 (emissions).
RF Exposure
WARNING: This equipment is approved only for mobile and base station transmitting devices,
separation distances of (i) 20 centimeters or more for antennas with gains < 6 dBi or
(ii) 2 meters or more for antennas with gains ≥ 6 dBi should be maintained between
the antenna of this device and nearby persons during operation. To ensure
compliance, operation at distances closer than this is not recommended.
The preceding statement must be included as a CAUTION statement in manuals for OEM products
to alert users on FCC RF Exposure compliance.
MaxStream Modules are pre-FCC approved for use in fixed base station and mobile applications.
As long as the antenna is mounted at least 20 cm (8 in) from nearby persons, the applicatio
considered a mobile application. If the antenna will be mounted closer than 20 cm to nearby
persons, then the application is considered “portable” and requires an additional test perfor
on the final product. T
n is
med
his test is called the Specific Absorption Rate (SAR) testing and measures
th t the person.
Ov r use with MaxStream 900
MH
the l of approved antennas, MaxStream requests that you send specific information
ab will evaluate whether
e antenna is covered under the FCC certification.
e emissions from the module and how they affec
er 100 additional antennas have been tested and are approved fo
z Modules (including “Mag Mount”, “Dome”, “Multi-path” and “Panel” antennas). Because of
arge number
out an antenna you would like to use with the module and MaxStream
th
©2006MaxStream,Inc.ConfidentialandProprietary 48
Downloaded from Elcodis.com electronic components distributor
To Next Page
Loading...
Need help?
General
