516532 B PUBLICATION DATE 1 JUN 2007.DOC PROGRAMMING MANUAL 41
• Select View Fault Messages by the ENTER Button to see the
20 Fault messages kept in memory.
• There are 20 Fault Messages kept in EEPROM memory.
• Fault N° 1 : the last occurred Diagnostic message.
Fault N° 2 : the last –1 occurred Diagnostic message.
…
Fault N° 20 : the last – 19 occurred Diagnostic message.
• D XXX : The Diagnostic message number
• YYYYYYYYYY : The Diagnostic message name
• If no messages are displayed, this means that no Errors have
occurred.
• Press the YES and ENTER button if you want to
erase the Fault messages.
• The Fault Statistics are an accumulation of Diagnostic
messages that have appeared over a long period.
• The Statistics can be reset at the Service Menu, by a Reset
of the Cycle counter.
• With this information, the technician has an indication of what
is in need of repair.
The List with Statistics.
No Drain : D8
Door Switch : D6 + D4 + D10 + D14
Bimetal / Spring : E17
No Fill : D7
Temp Sensor : D2
Level Sensor : D1
Mitsubishi Alarm : D12 + H61 + H62 + H63
PWM Drive Alarm : D11 + D12
Mitsu. Commun. Alarm : D11
View Fault Statistics
Service Faults
Erase Fault Messages No
Service Faults
View Fault Messages
Service Faults
1 Fault 1: D XXX: YYYYYYYYYYYY
2 Fault 2: D XXX: YYYYYYYYYYY
3 Fault 3: D XXX: YYYYYYYYYYYY
4 Fault 4: DXXX: YYYYYYYYYYY
Service Faults
1 No Drain 0x
2 Door Switch 0x
3 Bim/S
rin
0x
4 No Fill 0x
Service Statistics
To Next Page
Loading...
Need help?
General
