3-67
1. To reinstall the basket, lay a couple 2 x 4s
in the bottom of the tub for the basket to
slide in on. Make sure to stay in front of the
electric element receiving brackets.
2. Position the basket in front of the tub. Use
pallets and boards as needed to get the
basket to the level of the boards in the tub.
3. Push the basket about half way into the tub.
4. Install a centering rod in the center hole of
the shaft, through the opening in the tub.
5. Using two people, one person to push the
basket into tub, the other person to guide
the shaft through hole in the tub. Keep the
shaft centered in the hole. Avoid touching
the sides of the hole on the way through.
6. Make sure boards below the basket do not
get up onto the heater brackets at the back
of the tub, or the basket will be positioned
too high for the shaft to be centered.
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before
operating.
BASKET REINSTALL
Element
Brackets
Centering
Rod
Heater
Brackets
To Next Page
Loading...
