●
CARBURETOR ADJUSTMENT
DANGER
A
I
IF ANY ADJUSTMENTS ARE MADE TO THE ENGINE
WHILE THE ENGINE IS RUNNING (E.G. CARBURE-
TOR), KEEP CLEAR OF ALL MOVING PARTS. BE
CAREFUL OF HEATED SURFACES AND MUFFLER.
ENGINE SPEED
Your engine speed has been factory sat. Do not attempt 10
increase engine speed or it may resuk in unil damage or
personal injury. 1{you believe the engine is running 100 fast or
too slow, take your Chipper/Shredder
IO the nearesl service
Center for repair and adjustment.
Minor carburetor adjustment may be required to compensate for
differences in fuel, temperature, altitude or bad.
.NOTE: A dirty air cleaner will cause engine to run rough. Be
certain air cleaner is dean and attached to the carburetor before
adjusting carburetor. Do not make un-necessary adjustments.
Factory settings are satisfactory for most applications and
conditions. If”adjustment is needed, refer to the separate engine
manual packed with your unit.
SERVICE RECORD -
Fill in datea as you complete
regular service
;heck Fuel
lrain Fuel
I
Service Air Cleaner
Replace Fuel Filter .
Clean Enaine Cylinder Fins
After
First
5
Hours
,/
-
L
SCHEDULE
4
.1
I
I
Before
Storage
SERVICE” DATES
The service Recommendations Chart is supplied to assist the operator in proper maintenance of the chipper-shredder. This is only a
check list; instructions will be found in the Maintenance and Service A@4menl sections 01 this manual:
a
443
To Next Page
Loading...
