Need help?Do you have a question about the McCulloch Pro-Mac 5000 and is the answer not in the manual?
Read manual, be familiar with controls, keep manual safe.
Wear safety goggles, work gloves, shoes; avoid loose clothing.
List of items included in the product's shipping carton.
List of tools needed for the assembly process.
Locate and remove items from carton, check for missing or damaged parts.
Position and attach the shredder hopper to the unit.
Attach the discharge deflector to the shredder housing.
Attach the collector bag to the discharge opening.
Chipper-Shredders conform to safety standards of the American National Standards Institute.
Identify and understand the function of various controls.
Place shredder on level surface, service engine, attach spark plug wire.
Steps to start the engine, including choke and throttle settings.
Steps to properly stop the engine.
Methods of operation for shredding small branches and leaves.
Rake leaves and twigs into the hopper when it's in the ground position.
Feed bulky material and heavy branches into the chipper chute.
Clean and reset spark plug gap, recommended replacement.
Remove dirt and debris, clean blower housing periodically.
Do not operate without muffler, inspect and replace if necessary.
Clean the unit with water, wash the bag.
Lubricate wheel hubs, hopper assembly rotating plate, and caster wheel.
Refer to separate engine manual for engine oil maintenance.
Service air cleaner every 25 hours or season, clean more often if dusty.
Replace fuel filter once each season or if clogged.
Avoid indoor/enclosed storage if gasoline remains in the tank due to fire risk.
Run engine until empty, use stabilizer, clean unit, inspect parts, store in dry area.
Sharpen or replace dull chipper blades; do not use a hand file.
Steps to disconnect spark plug, remove chute, and then the chipper blade.
Shredder blade is reversible; sharpen or replace when dull.
Steps to remove and install the shredding blade.
Test and balance the shredding blade for proper operation.
Flails are permanently attached; contact dealer for replacement if damaged.
Minor adjustments may be needed for fuel, temperature, altitude, or load.
Engine speed is factory set; do not alter; contact service if issues arise.
Possible causes and corrective actions for engine starting issues.
Possible causes and corrective actions for power loss or erratic operation.
Possible causes and corrective actions for engine overheating.
Possible causes and corrective actions for excessive vibration.
Possible causes and corrective actions for discharge issues.
Diagram and part number for the muffler guard assembly.
Diagram and list of parts for the engine and main body.
Diagram and parts list for the wheel assembly.
Diagram and parts list for the hopper assembly.
Diagram and parts list for the flail housing assembly.
Diagram and parts list for the chipper chute assembly.
Diagram and parts list for the chute tube and plate assembly.
Diagram and list of various decals for the unit.
Diagram and parts list for included tools like tamper and goggles.
Diagram and parts list for the bag collector assembly.
10 foot hose attachment for vacuuming leaves and debris.
Kit to tow the Chipper/Shredder behind a tractor.
Kit for added maneuverability.
Complete kit to tow the Chipper/Shredder behind a tractor.
List of tools needed for installing the vacuum hose attachment.
Steps for attaching the vacuum hose adapter to the hopper.
List of tools needed for assembling the hitch bar kit.
Steps for attaching the hitch bar kit pivot bracket and tongue.
List of tools needed for assembling the caster wheel kit.
Steps for attaching the caster wheel assembly to the unit.
List of tools needed for assembling the towing kit.
Steps for attaching the towing kit's hitch bar pivot bracket and tongue.
To Next Page
General
