,.
●
THIS KiT INCLUDES THE FOLLOWING:
Your vacuum hoso attachment comes completely
assembled and ready to use with your Chipper/Shredder.
TOOLS REQUIRED FOR ASSEMBLY:
1-
Wire Cutlers (or knite)
TO INSTALL VACUUM HOSE:
.
●
●
●
●
●
✎
Remove hose attachment from carton and remove the
(2) sIraps holding the handle to the tube.
Lay the hose attachment out straight on the ground to
remove any twist in the hose.
With the enctine stopped, insert the hose attachment
adapter (#730) into the hopper assembly tube (See
Fg. 1) and turn approximately 1/6 of
aturn counterclock-
wise until the adapter locks in place.
The hose attachment can” be used with th’e hopper
assembly in the “up- position but performance is in-
creased by rotating the hopper assembly to the ground.
The vacuum hose attachment”works best when used on
dry leaves, grass, etc. If the mate~al is too wet, or if a
large twig, etc. enters the hose, clogging may o=ur. [f
your vacuum hose becomes clogged, stop the engine,
remove the adaptor from the hopper assembly, hold the
hose in a vertical position and shake the hose. until the
hose is clear.
Periodically, after use, flush the inside of the hose with
water using standard garden hose.
service parts: (See Fig. 2)
●
Key#
730
732
734
736
738
744
746
748
749
750
Part#
324712
39909
41629-853
328178
271172
41631
41632
36602
120385
48261
Description
Adapter Hose Attachment
Clamp Hose
Handle
.
Grip, Handle
Nut, 1/4-20 REGHEXKEPS
Clamp, Intake
Clamp, Intake
Botl, 114-20x.63 CARR.
Washer, flat .31 2x.73x
Tube. Flex
TCJ--::ER /
ROTATION
.
:;
._
25
467
To Next Page
Loading...
