.,, ,,,
Engine fails to start
Loss of power;
operation erratically
Engine overheats
●
Too much vlbratlon
Unfts does not dlscharg
.
.
.,.
POSSIBLE CAUSE (S)
1. Fuel tank empty, or stale fuel.
2. Spark plug wire disconnected.
,3. Faulty spark plug.
4. .Dirty fuel filter, (is so equipped)
1. Spark plug wire loose.
2. Unit running on CHOKE.
3. Bkxked
fuel line or stale fuel.
4. Water or dirt in fuel system.
5. Carburetor out of adjustment.
6. Dirty air cleaner. ,
1. Carburetor not adjusted properlj
2.
Engine oil level few.
3. Engine txoling fins blockd.
1.
Loose parts or damaged impelle
1. Discharge chute cfogged.
2. Foreign
object lodged in”impellei
CORRECJJVE ACTtON”
1. Fill tank
with clean, fresh fuel.
,.,
2.
Connect wire to sparkplug.
3. Clean,
adjust gap or replace.
4. Replace fuel filter. (if so equipped)
1. Connect and tighten spark plug wire.
2. Move choke lever to OFF position.
3. Clean fuel line; fill tank with clean fresh gasolin
4. Disconnect fuel line at carburetor to drain fuel
tank “Refill with fresh fuel.
5. Adjust carburetor or contact your Service Cente
6; Clean air filter.
1. Adjust carburetor or contact your Service Cente
2, Fill crankcase with proper oif.
3. Clear debris from fins.
1. Stop engine immediately and disconnect spark
plug wire. T@hten all botts and nuts.
Make all
necessary repairs. If vibration continues, have
unit service by a Service Center.
1.
Stop engine immediately and disconnect spark
plug wire. Clean inside of blower housing. See
Service/Adjustments se@on of this manual.
2. Stop engine immediat@y and disconnect spk
plug wire. Remove bcfged object.
IT12For repairs beyond the minor adjustments listed above, please contact your nearest Service Center.
..
14
445
To Next Page
Loading...
