.,
● ’
,.
BEFORE STARTING
1- place
the shredder on a“firm, Ievol surface.
!?
Service Ongino with gasolino and oil as instrucfod in the
-. —
scparale engino manual packed with your shredder.
3. Insure
spark plug wire is attached to spark plug.
[
A
DANGER
A
BE
SURE NO ONE OTHER THAN THE OPERATOR IS
sTANDING NEAR THE CHIPPER-SHREDDER WHILE
STARTING OR OPERATING.
A
WARNING ~
A
THE CHIPPEIVSHREDDER IS SHIPPED WITHOUT
GASOL!NE IN THE FUEL TANK AND VERY LMLE OIL
IN -THE ENGINE CRANKCASE DO NOT OPERATE
ENGINE UNllL CRANKCASE HAS BEEN FILLED WITH
OIL AS SPEC!FIED IN THE ENGINE MANUAL PRO-
VIDED WITH THE MACHINE.
TO START ENGINE:
●
●
●
●
Insure spark plug wire and rubber boot is attached to spark
plug (See Engine Manual).
Turn fuel shut-off valve to “ON” position (if so equipped)
(see Engine Manual).
Push stop switch to “ON” pq:ition (if so equipped).
Move choke control lever to “CHOKf3FULL CHOKI?
positiin. (See Engine Manual)
Move throttle control lever to ‘FAST/OWRUN” position.
Grasp starter handle (See
Engine Manual) and pull rope
out slowly until engine reaches start of compression cycle
(rope will pull slightly harder at this point. Let the rope rewind
slowly.
.
Pull the rope with a rapid, continuous, full arm ~troke. Keep
a firm grip on start handle. Let rope rewind slowly. DO NOT
let starter handle snap back against starter. ~~
Repeat preceding two (2) instructions until engine fires;
When engine starts, move choke lever on engine halfway
between ”CHOKE/FULLCHOKF and”RUN/NO CHOK15.
Move throttle control to idle rm.ition for a few minutes to
allow engine to warm-up. When engine is warm move
choke lever to “RUN’* position.
NOTE Inorderto idle srncmthly, a new engine mayrequirethree
(3) to five (5) minutes running above slow idle speed. Idle speed
has been adjusted to be correct after this break-in period.
TO STOP ENGINE:
.
Move throttle ~ntrol lever to”* OFF/STOP/SLOW” position.
(See Engine Manual) .
. Push stop switch to ‘OFF” position (if so equipped).
. Do not choke carburetor to stop engine. Backfire or engine
damage may resuft if choke is used to stop engine.
NOTE: Close fuel shutoff va~e (if so equipp+) when transporting
or
flOt operating Chipper/Shredder, to prevent fuel leakage.
HOW To USE YOUR
CHIPPER-SHREDDER:
The ChipporC3hrcddor k do:.qned for three (3) difforont moth
ods of operation
‘A
DANGER
A’
THECHIPPER-SHREDDER DISCHARGESMATERIALS
WITH CONSIDERABLE VELOCITY. KEEP AWAY FROM
THEAREAAROUNDTHE DISCHARGE ALWAYS STOP
THE ENGINE AND DISCONNECT THE SPARK PLUG
W!RE WHEN REMOVING OR AITACHING THE BAG
WHEN CHANGING CONTAINERS OR WHEN REMOV-
ING THE SHREDDED MATERIAL
WEAR SAFETY
GIASSES AND GLOVES WHENEVER USING YOUR
CHIPPER-SHREDDER.
d
● Leaves and small branches can be fed into the Hewer
assembly when !! is in the raised
positiin (See FfG:2-6P).
It it
becomes necessary to push material into the Ctipper/
Shredder, use the supplied debris tamper - NOT YOUR
HANDS:
(A
DANGER
A
.
ANY AITEMPTTO PUSH MATERIAL WITH ANYTHING
OTHER THAN THE DEBRIS TAMPER CAN RESULT IN
PERSONAL INJURY AND/OR MACHINE DAMAGE.
m“i
..,.,.,.,.,,.,:.
431
To Next Page
Loading...
