Fusion Equipment Safety
1 - 4
Electrical Safety
Always ensure power cords are properly
grounded. It is important to remember that you
are working in a wet environment with electrical
devices. Proper ground connections help to
minimize the chances of an electric shock.
Frequently inspect electrical cords and unit for damage. Have
damaged components replaced and service performed by a
qualified electrician.
Do not carry electrical devices by the cord.
NOTICE: Always connect units to the proper power source as
listed on the unit, or in the owner's manual. On units with two
power cords, plug each cord into separate power circuits. Do not
plug into both outlets of one duplex receptacle.
NOTICE: Disconnect the machine from the power source before
attempting any maintenance or adjustment.
TX00105-4-12-93
WR00055-4-7-93
WR00025-11-30-92
Battery
Do not expose the battery to flames or electrical
sparks. Hydrogen gas generated by battery action
is explosive. Blindness or serious injury can result
from an exploding battery.
Do not allow battery fluid to contact your skin, eyes,
fabrics, or painted surfaces. Sulfuric acid can cause
burns. After touching a batter or battery cap, do not
touch or rub your eyes.
Thoroughly wash your hands. If the acid contacts
your eyes, skin or clothing, immediately flush with
water for at least 15 minutes and seek medical
attention.
CD00176-9-14-95
TX00650-9-14-95
CD00177-9-14-95
To Next Page
Loading...