Install Heater Adapters
Heater is Not Explosion Proof. Operation of
heater in a hazardous environment without
necessary safety precautions will result in
explosion and death.
If operating in a hazardous environment, heater
should be brought up to temperature in a safe
environment, then unplugged before entering the
hazardous atmosphere for fusion.
Select appropriate heater and sidewall fusion heater adapters.
Clean heater surfaces and adapter surfaces. Attach the adapters
to the heater.
Place heater in insulated heater blanket.
Plug heater into the vehicle.
IMPORTANT: Engine must be in high speed to provide electric
power to the heater.
TX01888-11-15-00
Saddle Fusion Procedure for TracStar No.28CU
The combination unit is capable of saddle fusing up to an 8"
(200 mm) branch on any size main.
TX00454-9-22-94
Special Operations
- Saddle Fusion Procedure
PH00406-9-21-94
5 - 1
PH00416-11-1-94
PH00418-11-1-94
Assure Saddle Will Fit
For branch saddles, a nipple long enough to extend through
both movable jaws should be fused to the fitting using standard
butt fusion procedures.
TX00456-9-15-94
PH00423-11-1-94
To Next Page
Loading...