Fusion Equipment Safety
1 - 7
Periodically Check Temperature
NOTICE: Incorrect heating temperature can result in bad fusion
joints. Check heater plate surface temperature periodically with a
properly calibrated pyrometer, and make necessary adjustments.
The thermometer on heaters indicates internal temperature, and
should be used as a reference only.
TX00107-11-13-95
WR00077-4-16-93
Positioning Fusion Machine
Place fusion machine on as level ground as possible. If it is necessary to
operate machine on unlevel grade, chock the tracks and block the unit to
make it as stable as possible.
TX01889-11-15-00
CD00633-9-27-00
Fusion Procedures
Obtain a copy of the pipe manufacturer's procedures for the pipe
being fused. Follow the procedure carefully, and adhere to all
specified parameters.
Failure to follow pipe manufacturer's procedure
could result in a bad joint. Always follow pipe
manufacturer's procedures.
TX00113-4-12-93
WR00079-1-24-96
Hearing Protection Required
When operating machine for more than 4 hours per day wear
hearing protection.
TX01890-11-15-00
WR00028-1-24-96
To Next Page
Loading...