2 - 7
Overview
Heater
This Heater Is Not Explosion Proof. Operation
of heater in a hazardous environment without
necessary safety precautions will result in
explosion and death.
The heater temperature is controlled by a microprocessor. It has a
red indicator light on the handle at the bottom of the temperature
scale. When the heater is plugged in and preheating the light
glows steadily until the set temperature is reached. The light then
goes off and on slowly as the heater maintains temperature.
Coated butt fusion heater adapters are available for non-coated
heaters.
NOTICE: Non-coated heaters should never be used without butt
fusion heater adapters installed.
To prevent a build-up of plastic pipe residue from accumulating
on the heater plates (loss of surface temperature and pipe sticking
may result), the heater plates should be cleaned with a non-
synthetic cloth before and after every fusion joint.
TX02033-7-08-02
PH02334-7-08-02
PH02313-7-08-02
PH02333-7-08-02
To Next Page
Loading...