McIntosh C47 User Manual

14
16. Rotate the INPUT Control until the character “A”
LVIODVKLQJWKHQURWDWHWKH92/80($'-867
Control to change the character “A” to “E”. Refer
to figure 10.
5RWDWHWKH,1387&RQWUROXQWLOWKHFKDUDFWHU³/´
LVIODVKLQJWKHQURWDWHWKH92/80($'-867
&RQWUROWRFKDQJHWKHFKDUDFWHU³/´WR³'´5HIHU
to figure 11.
18. Rotate the INPUT Control until the “_” empty
space to the right of character D is flashing, then
URWDWHWKH92/80($'-867&RQWUROWRFKDQJH
the “_” empty space to character to “I”. Refer to
figure 12.
19. Repeat steps 15 thru 18 until the new name of “
5(1$0(%$/0(',$%5'*´LVLQGLFDWHG
on the Front Panel Display. Refer to figures 13
thru 19.
6(78381%$/2II´5HIHUWRILJXUH
([LWWKH6(7830RGHE\VHYHUDOSUHVVHVRIWKH
INPUT Control.
,QWKHIROORZLQJH[DPSOHWKH81%$/,QSXWZLOOEH
switched On.
Notes: 1. When an INPUT is swiched ON, its name will
appear on the Front Panel Information Display
when using the INPUT Control (Front Panel or
Remote Control).
6. Press and hold in the INPUT Control to enter the
6(78302'(5HIHUWRILJXUHRQSDJH
5RWDWHWKH,1387&RQWUROXQWLO³6(783,QSXWV
+ROG,1387DSSHDUVRQWKH,QIRUPDWLRQ'LVSOD\
Refer to figure 3, on page 13.
3UHVVDQGKROGLQWKH,1387&RQWUROXQWLO³6(7-
UP: _______, Off” appears on the Display. If
necessary rotate the INPUT Control to select the
81%$/,QSXW5HIHUWRILJXUH
7RVZLWFKWKH81%$/,QSXW2QURWDWHWKH92/-
80(&RQWUROXQWLOWKHGLVSOD\LQGLFDWHV6(783
81%$/2Q5HQDPH´5HIHUWRILJXUHRQ
page 13.
([LWWKH6(7830RGHE\VHYHUDOSUHVVHVRIWKH
INPUT Control.
5(1$0(,1387
,QWKHIROORZLQJH[DPSOHWKH%$/$1&('%$/
,QSXWZLOOEHUHQDPHGWRPDWFKXSZLWKWKHFRPSR-
QHQWFRQQHFWHGUHIHUWRSDJHVWHS
7KH&'HIDXOW,QSXW1DPHV81%$/%$/
&2$;HWFDVLQGLFDWHGRQWKH)URQW3DQHO'LV-
play can be customized to a different name up to ten
FKDUDFWHUVORQJ781(5&'3/$<(5HWF7KH
available characters for renaming the input include the
following: ! < > * , / - _ 0 1 2 3 4 5 6 7 8 9 A B C D E
)*+,-./0123456789:;<=
,QWKHIROORZLQJH[DPSOHWKH%$/,QSXWZLOOEH
UHQDPHGWR³0(',$%5'*´
11. Press and hold in the INPUT Control to enter the
6(78302'(5HIHUWRILJXUHRQSDJH
5RWDWHWKH,1387&RQWUROXQWLO³6(783,QSXWV
+ROG,1387´DSSHDUVRQWKH,QIRUPDWLRQ'LV-
play. Refer to figure 6.
3UHVVDQGKROGLQWKH,1387&RQWUROXQWLO³6(7-
83%$/2Q5HQDPH´DSSHDUVRQWKH'LVSOD\
If necessary rotate the INPUT Control to select the
%$/,QSXW5HIHUWRILJXUH
14. Press and hold in the INPUT Control until “RE-
1$0(%$/!%$/´DSSHDUVRQWKH
Display. The character “B” is flashing to indicate
it is ready to be changed. Refer to figure 8.
5RWDWHWKH92/80($'-867&RQWUROWRFKDQJH
WKHFKDUDFWHU³%´WR³0´5HIHUWRILJXUH
Input Settings, con’t
Figure 5
SETUP: UNBAL 3
Off
Figure 7
SETUP: BAL 1
On
/
Rename
Figure 9
RENAME: BAL 1
>MAL 1 <
Figure 14
RENAME: BAL 1
>MEDIA <
Figure 11
RENAME: BAL 1
>MED 1 <
Figure 10
RENAME: BAL 1
>MEL 1 <
Figure 13
RENAME: BAL 1
>MEDI <
Figure 6
SETUP: Inputs
(Hold INPUT)
Figure 8
RENAME: BAL 1
>BAL 1 <
Figure 12
RENAME: BAL 1
>MED <

McIntosh C47 Specifications

General

Type	Solid State Preamplifier
Total Harmonic Distortion	0.003%
Power Consumption	30 watts
Frequency Response	20Hz - 20kHz (+0, -0.5dB)
Phono Stage	Yes
Digital Inputs	2 Coax, 2 Optical, 1 USB
USB Input	Yes
Headphone Output	Yes
Weight	25 lbs (11.3 kg)
S/N Ratio	100dB
Signal to Noise Ratio	100dB (Line), 80dB (Phono)
Gain	15dB (High Level), 40dB (Phono)
Output Impedance	200 Ohms
Inputs	1 Balanced, 3 Unbalanced, 1 Phono MM
Dimensions	17-1/2" (44.45cm) wide, 6" (15.24cm) high (including feet), 18" (45.72cm) deep (including front panel and cables)