McIntosh C47

18
Power Mode
The C47 incorporates an Auto Off Feature, which
automatically places the preamplifier into the Power
6DYLQJ6WDQGE\2II0RGH7KLVRFFXUVDSSUR[LPDWHO\
30 minutes after there has been an absence of user ac-
tivity (includes changes to any of the Operation Func-
WLRQVVXFKDVVRXUFHVHOHFWLRQYROXPHDGMXVWPHQWHWF
or absence of an audio signal. If it is desirable to dis-
able the Auto Off Feature perform the following steps:
1. Press and hold in the INPUT Control to enter the
6(78302'(5HIHUWRILJXUHRQSDJH
5RWDWHWKH,1387&RQWUROXQWLO³6(783$XWR
Off, Enabled” appears on the Information Display.
Refer to figure 46.
5RWDWHWKH92/80($'-867&RQWUROWRVHOHFW
Disabled. Refer to figure 47.
3UHVVWKH(4%<3$666(7833XVKEXWWRQWRH[LW
WKH6HWXS0RGH
Figure 46
SETUP: Auto Off
Enabled
Figure 47
SETUP: Auto Off
Disabled
IR Sensor
7KH&)URQW3DQHO6HQVRUZKLFKUHFHLYHVWKHVLJ-
nals from the HR085 Remote Control, can be switched
RIIWRSUHYHQWLQWHUIHUHQFHZKHQDQH[WHUQDO,56HQVRU
LVFRQQHFWHG7RGHDFWLYDWHWKH)URQW3DQHO,56HQVRU
perform the following steps:
1. Press and hold in the INPUT Control to enter the
6(78302'(5HIHUWRILJXUHRQSDJH
5RWDWHWKH,1387&RQWUROXQWLO³6(783)URQW
IR, Enabled” appears on the Information Dis-
play. Refer to figure 44.
5RWDWHWKH92/80($'-867&RQWUROWRVHOHFW
Disabled. Refer to figure 45.
([LWWKH6(7830RGHE\VHYHUDOSUHVVHVRIWKH
INPUT Control.
Figure 44
SETUP: Front IR
Enabled
Figure 45
SETUP: Front IR
Disabled
Factory Reset
If it becomes desirable to reset all the adjustable set-
WLQJV6HWXSDQG7ULP6HWWLQJVWRWKHIDFWRU\GHIDXOW
values, perform the following steps:
1. Press and hold in the INPUT Control to enter the
6(78302'(5HIHUWRILJXUHRQSDJH
2. Rotate the INPUT Control until “FACTORY RE-
6(7+ROG,1387´DSSHDUVRQWKH,QIRUPDWLRQ
Display. Refer to figure 48.
3. Press and hold in the INPUT Control until “FAC-
725<5(6(7,Q3URJUHVV´DSSHDUVRQWKH,QIRU-
mation Display, then release the INPUT Control.
Refer to figures 49 and 50.
3UHVVWKH)URQW3DQHO67$1'%<3XVKEXWWRQWR
switch the C47 on.
Figure 50
FACTORY RESET
Completed!
Figure 48
FACTORY RESET
(Hold INPUT)
Figure 49
FACTORY RESET
In Progress!