17
The MP1100 incorporates an Auto Off Feature, which
automatically places the preamplifier into the Power
Saving Standby Mode. This occurs approximately 30
minutes after there has been an absence of user activ-
ity (includes changes to any of the Operation Func-
tions such as source selection, etc.) or absence of an
audio signal. If it is desirable to disable the Auto Off
Feature, perform the following steps:
1. Press and hold in the INPUT Control to enter the
SETUP Mode. Refer to figure 2 on page 13.
2. Rotate the INPUT Control until “SETUP: Auto
Off, Enabled” appears on the Information Display.
Refer to figure 28.
3. Rotate the LOAD Control to select Disabled. Refer
to figure 29.
4. Exit the SETUP Mode by several presses of the
INPUT Control.
Setup, con’t
Power Mode
Figure 28
Figure 29
Factory Reset
If it becomes desirable to reset all the adjustable set-
tings (Setup and Trim Settings) to the factory default
values, perform the following steps:
1. Press and hold in the INPUT Control to enter the
SETUP Mode. Refer to figure 2 on page 13.
2. Rotate the INPUT Control until “FACTORY RE-
SET, (Hold INPUT)” appears on the Information
Display. Refer to figure 30.
3. Press and hold in the INPUT Control until “FAC-
TORY RESET, In Progress!” appears on the Infor-
mation Display, then release the INPUT Control.
Refer to figures 31 and 32.
4. Press the Front Panel STAND/BY Push-button to
switch the MP1100 on.
Figure 32
Completed!
Figure 30
(Hold INPUT)
Figure 31
In Progress
To Next Page
Loading...
Need help?
General
