McKesson TRUEresult - Time;Date

Set Up of Time, Date, Ketone Alert, Testing Reminders
Note: Setting up the time, date, Ketone Alert and Testing Reminders may not be
suitable for a multi-patient use of the System. Check with the facility
procedures and policies before performing Set Up.
Note: If the Meter turns off at any time during the Set Up, go back to Step #1
under Time/Date and begin again.
Time/Date
1. Press and hold the “S” Button until tone sounds (around 30 seconds). Release
“S” Button. The Full Display appears and the Meter goes into Set Up.
2. The hour flashes. To change, press “+” or “-“ Buttons on the top of the
Meter to select the hour. Like many alarm clocks, to set “AM” or “PM”,
scroll through the hours until “AM” or “PM” appears in the Display next to
the time. Press the “S” Button to set.
Note: “AM” or “PM” will not display if the Meter is factory set to a 24-hour
clock.
3. The minutes flash. To change, press “+” or “-“ Buttons on the top of the
Meter to select the minutes. Press the “S” Button to set.
4. The month (number) flashes. To change, press “+” or “-“ Buttons to on the
top of the Meter to select the month. Press the “S” Button to set.
5. The day (number) flashes. To change, press “+” or “-“ Buttons to on the top
of the Meter to select the day. Press the “S” Button to set.
6. The year flashes. To change, press “+” or “-“ Buttons to on the top of the
Meter to select the year. Press “S” Button to set.
Note: The day of the week (Mon, Tue, Wed, Thu, Fri, Sat, Sun) self-adjusts
when the month, day or year are changed.
Note: The Meter beeps every time a setting is confirmed (when the “S” Button
is pressed).
TRUEresult
®
Quality Assurance / Quality Control Manual
33
Full Display