© 2008 McNeilus Truck and Manufacturing, Inc.
Rear Loader
61
Operation
3
4
Figure 25
1. Sweep panel in open position.
2. Slide panel in lower position.
3. Sweep panel in closed position.
4. Slide panel in raised position.
3.7 Refuse Ejector Procedure
Ejecting refuse from the vehicle involves multiple functions.
Do not back up until you are sure the area
behind the vehicle is clear.
DANGER
1. Position rear loader appropriately for ejecting refuse.
WARNING
Be sure the area around the vehicle is clear of
non-operator personnel before and while
performing the refuse eject procedure.
Serious personal injury or death may result if
someone is near these areas while they are in
operation.
2. Unlock the turnbuckle (or optional hydraulic locks) and
open the tailgate. See Section 2.4 Turnbuckle and
Optional Hydraulic Tailgate Lock Operation and Section
2.5 Tailgate Functions for details.
3. Push the ejector control lever to dump the load (Figure
26).
4. Close the tailgate and lock the turnbuckle or optional
hydraulic lock.
5. Pull the ejector control lever to retract the ejector.
To Next Page
Loading...
