McNeilus XC Rear Loader - Preventive Maintenance Intervals; Preventive Maintenance; DOT Pre-Trip

© 2008 McNeilus Truck and Manufacturing, Inc.
Rear Loader
81
1.0 Preventive Maintenance
Check or inspect the unit each day or before each new shift
of operation. Report any deciencies to your Maintenance
Department for correction by skilled service personnel.
CAUTION
Correct all identified deficiencies BEFORE
operating the Packer. Failure to correct
deficiencies may cause damage to
equipment.
1.1 DOT Pre-Trip
Preform pre-trip inspection of chassis and refuse vehicle
according to all federal, state, and local laws.
2.0 Preventive Maintenance
Intervals
Performing preventive maintenance on your refuse vehicle
will prolong the life of its equipment, help prevent expensive
downtime, and minimize the potential for problems arising on
the route.
The following Preventive Maintenance Chart summarizes the
requirements to properly maintain your refuse vehicle.
The chart species the recommended interval when each item
should be performed.
Intervals are listed in calendar and hours-of-use increments.
Maintenance should be performed at the increment that
occurs rst.
The preventive maintenance intervals listed under the Service
group heading are the maximum days or hours allowed
for each maintenance procedure. Continue to repeat the
maintenance procedures at the listed intervals.
NOTE
If the Packer is operated more hours per
day or double-shifted, the maintenance
interval must be adjusted accordingly.
Preventive Maintenance