IOMM Starter 47
Fault
Code
Description Detailed Description of Fault / Possible Solutions
If fault persists after performing a Factory Parameter reset, consult factory.
F96 CPU Error The D3 control has detected an internal CPU problem. Consult factory.
F97
CPU Error –
SW Watchdog
Fault
The D3 control has detected an internal software problem. Consult factory.
F98 CPU Error The D3 control has detected an internal CPU problem. Consult factory.
The non-volatile program memory has been corrupted.
F99
CPU Error –
Program
EPROM
Checksum Fault
Consult factory. Control software will need to be reloaded in to the D3 control card
before normal operation can resume.
To Next Page
Loading...
