MDC XT 14E 2021 - Page 78

www.marketdirect.com.au
I
Ph: 1300 494 494 I ©Copyright Page | 78
12 MONTHS / 10,000KM SERVICE
CHECKED
Chassis and Suspension
Hitch
• Inspect for damage and lubricate. Check bolt Torque
to 90Nm
Jockey
Wheel
• Inspect for condition and operation
Breakaway
• Check for correct operation.
• Inspect lanyard and clip
Drawbar
•
Inspect wiring grommets and general condition
Suspension
• Torque bolts to 190Nm
• Grease bushes and check for play.
• Check torque on suspension hanger bolts (190nm)
• Check retaining chain shackles tight.
• Inspect shock absorber for condition.
• Inspect shock absorber bushes
Brakes
• Inspect and adjust. Check lining thickness and drum
wear
Wheel
bearings
• Replace bearings, seals and lubricate. Check stub axle
condition and wear. Replace split pin.
Wheel Nuts
• Inspect condition and torque to 125Nm (12mm studs)
(140Nm 14mm studs alloy rims) (200Nm 14mm studs
steel rims)
Tyres
• Inspect for abnormal wear, damage, and pressure.
• Check manufacturing date less than 5 years.
• Check sidewalls for perishing and damage.
12 volt electrical
Lights
• Check all trailer lights are functioning.
• Check plug pins have gap.
• Check for corrosion
Battery
• Check terminals and voltage at full charge.
• Check batteries are secure in cradles
Charging
• Check battery charger settings are correct.
• Check DC to DC charger settings are correct
Solar Panels
• Check panels are free of damage.
• Inspect sealants on cable penetrations and junction
boxes
Cables
• Inspect cables under body for damage to conduits.
• Inspect cable glands and sealants on penetrations
through floor
240 volt Electrical
RCD Unit
•
Check operation of RCD via test button
Mains Input
• Inspect mains input plug and cover are free of
damage
Earthing
•
Carry out resistance check
Caravan Body