MDS T7 - REMOTE TRIGGER CONNECTION; FUSE REQUIREMENTS

Now it’s time to connect the power and ground cables to the amplifier.
-

place them into the correctly marked terminals.
REM (Remote Trigger)

leads are provided at the source unit that will turn on and off the amplifier in correspond-
ence with the source. If the source unit does not have a remote turn-on lead, then a
power antenna wire can be used. If neither of these leads is available at the source unit,



wire from the amplifier location to the source of the switched
-



FUSE REQUIREMENTS
While the panel on your MDS amplifier incorporates one or more fuses, these do nothing
to protect the vehicle from a dangerous short circuit. It is absolutely vital that the main


the sum of the fuses found on all of the equipment being connected to that power wire.
10