MDS T7 - SPEAKER WIRING AND CONFIGURATIONS; SPEAKER (SUBWOOFER) LOAD; SUBWOOFER WIRING GUIDELINES

SPEAKER WIRING AND CONFIGURATIONS
Speaker (Subwoofer) Load

amplifier. In other words this amplifier requires a minimum impendance of 1-Ohm
mono to operate trouble free. Lower impedance will send the amplifier into protection
and possibly damage the electronics inside.
Subwoofer Wiring




when you ran the power cable. Terminate these wires at the subwoofer end using insu-


connections are positive-to-positive and negative-to-negative. Most speaker wire has
-

At the amplifier end, insert the speaker wires into the properly marked terminals. Use a

no bare wire ends touch each other. Such contact could result in an electrical short and

NOTE:
is used to tighten the screws on the terminal blocks. This will prevent stripping or
other possible damage to the amplifier.
CAUTION:


the amplifier. Detailed wiring diagrams are supplied with all MDS woofers.
-


DO NOT attempt to “bridge” the speaker outputs of this amplifier with the
speaker outputs of a second amplifier.
15