MDS T7 - SET UP ADJUSTMENTS; GAIN ADJUSTMENT; SUB-SONIC DDC ADJUSTMENT; LPF (LOW PASS FILTER) ADJUSTMENT

13
SET UP ADJUSTMENTS
GAIN
This control allows you to match the input level
of the amplifier to the output level of your head
unit. Matching the input can be accomplished

1. Make sure that the remote gain control is not plugged in until after the master
gain control is set.
2.
3.

4.
back off slightly to cut distortion and operate at optimum gain.
Remember, the GAIN control is not a volume control. Ignoring these four steps
above may leave you with damaged speaker and/or a damaged amplifier.
Sub-Sonic DDC Adjustment

-
cies lower than 33 Hz, it conserves amplifier power without audibly
affecting the quality of the sub-bass output.


LPF (Low Pass Filter) Adjustment
The crossover frequency adjustment filters out frequencies that you




sure to set the tone controls of your source unit to flat before adjust-


faster bass.