Page 53 65-J Diesel - Operator’s Manual
September 2022Section 11 - Transport and Lifting Instructions
Boom Lifting Instructions
Only qualied riggers should rig and lift this machine.
Ensure that the crane capacity, loading surfaces, chains, straps and
slings are sucient to withstand a machine weight of 20,000 lbs (9,070
kg).
Ensure that the platform is unloaded and that all material and tools have
been removed.
1. Rotate the turntable so that the
platform and boom are opposite
the steering axle. Lower the boom
completely so that it rests on the
front of the turntable.
2. Engage the Rotation Lock. Rotate
the turntable so that the center
of the three locking holes aligns
with the Rotation Lock located
on the chassis. The lock holes
are located on the bottom of the
Controls Module. The Rotation
Lock is located on the chassis
behind the left front wheel.
Lift the Rotation Lock using the
attached pin, then rotate to the
right and lower it into the shallow
depression to engage.
Steering
Wheels
ART_4743
Rotation Lock
Disengaged
Engaged
3. Place a 2-inch (5 cm) diameter
pin at least 30 inches (80 cm)
long through the hole at the
platform end of the turntable as
indicated in the illustration. Be
careful to avoid hydraulic lines.
Lift Hole
ART_4903
To Next Page
Loading...
