8
piezo smart - manual of use and maintenance
9
piezo smart - manual of use and maintenance
03.2 List of material included in the standard supply
1 Housing of the device (Fig.3 - Ref.A).
1 Scaler handpiece (Fig.3 - Ref.B).
2 Bottles (Fig.3 - Ref.C)
1 K3 torque wrench (Fig.3 - Ref.D).
1 Kit of 4 inserts.(Fig.3 - Ref.E).
1 Pedal with cable and plug (Fig.3 - Ref.F).
1 Peristaltic pump (Fig.3 - Ref.G).
1 External power supply unit (Fig.3 - Ref.H).
2 Bottle caps (Fig.3 - Ref.I).
This equipment may vary at the time of promotional campaigns.
04.0 Installation
04.1 Safety requirements during installation
DANGER: The wiring system of the premises where the device is installed and used
must comply with the applicable standards and with the relevant electrical safety
requirements.
DANGER: Do not install the equipment anywhere where there is a risk of explosions. The
equipment must not be used in places where there is an inflammable atmosphere
(anaesthetic mixtures, oxygen, etc.).
DANGER: Install the device in a place where it will be protected from blows and from
accidental sprays of water or other liquids.
DANGER: Do not install the device above or in the vicinity of sources of heat. Make sure
that there is sufficient air circulation around the device.
WARNING: The device is transportable, however it must be handled with care when it is
moved.
WARNING: Do not expose the device to direct sunlight or to sources of UV light.
B
A
C
D
E
F
H
G
Fig. 3
I
To Next Page
Loading...
