EN
Preparation for use / operating instructions | 27
Thopaz
+
is in Standby and is ready for use with the factory
settings. (To change factory settings please refer to chapter
10 – Changing settings)
5.
Connect the Thopaz
+
system to the patient catheter (drain)
according to hospital guidelines. To start the therapy press «On».
6.
Safety related tip
The acoustic alarm «Leak in system – 301» is deactivated for approximately 6 minutes
after Thopaz
+
is switched on.
Safety related tip
Everytime a new patient is connected, it is recommended to carry out the funtional
check.
To Next Page
Loading...
