6
This section contains information about setting up your instrument
and preparing to play. Please go through this section carefully before
turning the power on.
Power Supply
You can power the instrument either by batteries or by power adaptor.
Before you switch your instrument on, turn down the volume of
instrument and the connected audio equipment first.
Using Batteries
6 pieces of AA (NO.5) or equivalent alkaline batteries must first be
installed into the battery compartment.
1. Open the battery compartment cover located on the bottom cabinet
of the unit.
2. Insert the batteries; carefully follow the polarity markings on the
cabinet.
3. Replace the compartment cover, making sure that it locks firmly in
place.
Note:
1. Do not mix old and new batteries.
2. Always use same types of batteries.
3. Always remove the batteries from the unit when it is not being used
for an extended period of time.
Using Power Adapter
1. Connect the AC/DC adaptor to the power supply jack of this
instrument.
2. Press the POWER SWITCH, the LCD screen is lit, which indicates
the instrument has powered on.
3. If you are ready to turn off the instrument, press the POWER
SWITCH again.
Note:
1. In the idle mode, the instrument will automatically shutdown in 30
minutes if you do not take any action on the instrument (Please
refer to “Auto Power Off” for details).
2. When the keyboard is not in use or during thunderstorm, please
disconnect the power for safety purpose.
Setting a Music Stand
A music stand is supplied with the keyboard. You can easily attach it
to the instrument by inserting it into the slots at the rear of the panel.
Setup
12V
Open
VOLUME
To Next Page
Loading...
Need help?
General
