Medeli CDP5200 - Beattype; Metro Volume; Pedal Type; Reverb Volume

Function Menu
Beat Type
1. Holding down [SHIFT] button, and then press [FUNCTION ]
button to select beat type menu. LCD displays “xxx BeatType”.
Use [+/YES]/ [-/NO] or data dial to change beat type. The range of
beat type: 0, 2~9.
2. Press [+/YES] and [-/NO] simultaneously will set the beat type value
to its default setting: 004.
</>
25
Metro Volume
1. Holding down [SHIFT] button, and then press [FUNCTION ]
button to select beat volume menu. LCD displays “xxx MetroVol”.
Use [+/YES]/ [-/NO] or data dial to change beat volume. The range
of beat volume: 0~127.
2. Press [+/YES] and [-/NO] simultaneously will set the beat volume
value to its default setting: 090.
</>
Pedal Type
1. Holding down [SHIFT] button, and then press [FUNCTION ] button
to select pedal type menu. LCD displays “00x Pedal xxxx”.
Use [+/YES]/ [-/NO] or data dial to change pedal type. 3 types of
pedal are available: sustain pedal(Sust), accompaniment start/stop
Pedal(St/T), memory switch pedal(Mem).
2. Press [+/YES] and [-/NO] simultaneously will set the pedal type to its
default setting: Sust.
</>
BeatType
MetroVol
Pedal Sust
Reverb Volume
1. Holding down [SHIFT] button, and then press [FUNCTION ] button
to select reverb volume menu. LCD displays “xxx ReverbVol”.
Use [+/YES]/ [-/NO] or data dial to change reverb volume.
Range: 0~127
2. Press [+/YES] and [-/NO] simultaneously will set the reverb volume
to its default setting.
Note:
The reverb volume default value depends on the voice.
</>
ReverbVol
0
5
25
75
95
100
AW_CDP5200_Manual_G09_140718
2014󾾠󾾠7󾾠󾾠18󾾠󾾠 17:19:16