Function Menu
26
Chorus Volume
1. Holding down [SHIFT] button, and then press [FUNCTION ]
button to select chorus volume menu. LCD displays “xxx ChorusVol”.
Use [+/YES]/ [-/NO] or data dial to change chorus volume.
Range: 0~127
2. Press [+/YES] and [-/NO] simultaneously will set the chorus volume
to its default setting.
Note:
The chorus volume default value depends on the voice.
</>
Harmony Type
1. Holding down [SHIFT] button, and then press [FUNCTION ]
button to select harmony type menu. LCD displays “xxx xxxx”.
Use [+/YES]/ [-/NO] or data dial to change harmony type.
The harmony types are as follows:
</>
Number
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
LCD Display
Duet
StandardTrio
Full Chord
Rock Duet
Country Duet
Country Trio
Block
4 Close 1
4 Close 2
4 Open
1+5
Octave
Strum
Echo
Tremolo
Trill
2. Press [+/YES] and [-/NO] simultaneously will set harmony type to
default setting: Duet.
3. When the harmony type is echo, tremolo or trill, the speed of
harmony effect note can be adjusted. Please refer to the harmony
speed setting.
4. When the harmony type is strum, echo, tremolo or trill, the tempo
setting will also change the harmony note speed.
ChorusVol
Duet
Harmony Speed
When the harmony type is echo, tremolo or trill, the harmony speed
can set the harmony effect note speed to 4 default speed.
1. Holding down [SHIFT] button, and then press [FUNCTION ]
button to select harmony speed menu. LCD displays “xxx
HarmonySpeed”. Use [+/YES]/ [-/NO] or data dial to change
harmony speed. Range: 1~4.
2. Press [+/YES] and [-/NO] simultaneously will set the chorus volume
to its default setting:001.
</>
HarmonySpeed
To Next Page
Loading...
