Medivators SCOPE BUDDY - 7 WARRANTY; Limited Warranty; Limitation of Remedy; Warranty Disclaimer

MEDIVATORS REPROCESSING SYSTEMS
37
Troubleshooting Guide
Problem
Corrective Action
Timer display does not
illuminate when power switch
is turned on
Verify power cord is properly connected
If properly connected, then contact
Medivators Technical Support
Device display does not count
down after the START button
is selected
Contact Medivators Technical Support
Timer is counting down, but
no fluid draw at intake, or fluid
flow from discharge tubing
Verify Intake Tubing is properly connected
to front device connection point
Verify Intake Tubing end is fully
submerged in solution
Check if Intake Tubing screen is blocked,
clean or replace in necessary
Verify Outflow Tubing end is properly
connected to front device connection point.
With timer counting down, fill intake tubing
with fluid and lift it above unit. The unit may
now prime and begin pumping fluid.
Contact Medivators Technical Support
Device fails flow validation
test
Contact Medivators Technical Support
Fluid is leaking from unit Contact Medivators Technical Support
Audible tone is not heard at
the end of a pumping cycle
Contact Medivators Technical Support