Medivators SCOPE BUDDY - 2 SAFETY; Intended Use; Notes, Cautions, and Warnings; Electrical Compliance

MEDIVATORS REPROCESSING SYSTEMS
3
2 SAFETY
Intended Use
The Medivators SCOPE BUDDY Endoscope Flushing Aid is an electro-mechanical device intended to
pump fluids through channels of flexible, immersible endoscopes. The device is designed to be used as a
flushing aid only during the endoscope manual cleaning process.
This device is not an endoscope disinfector and does not take the place of an automatic endoscope
reprocessor. Endoscopes must be high-level disinfected by an approved endoscope reprocessor or
manual HLD soaking prior to use on a patient.
Throughout this manual are notes, cautions, and warnings, which are also represented by specific icons.
These are designed to provide important information to the user regarding the proper use and operation
of this device. It is important to read and understand all notes, cautions, and warnings, prior to using this
product. Should you have any questions or require further clarification, please contact your
manufacturer’s representative. Examples of these icons are shown below.
Note: A note refers to important information to which the user should pay special attention.
Notes provide added insight and helpful information which can be useful to the operator.
Caution: This information is an alert to the possibility of a problem with the device
associated with its use or misuse.
WARNING: This information is an alert to possible injury or other serious adverse reaction
associated with the use or misuse of this device.
WARNING: Do not use this device on NON-IMMERSIBLE endoscopes or on
endoscopes with internal leaks.
Electrical Compliance
SCOPE BUDDY has been rigorously tested to stringent electrical certifications and safety standards.
This device meets the laboratory standard for Electromagnetic Interference Requirements for FCC Title
47, Part 15, Class A, EN 55011 and EN 50082-1, and the Electrical Safety Requirements of UL 61010-1,
Pollution Degree 2, and Installation Category II Equipment.
SCOPE BUDDY carries and is certified to ETL and cETL, the Electrical CE Mark, UL 61010-1, and
CAN/CSA C22.2 No. 61010-1.
Caution: This device must always be plugged into an electrical wall outlet that includes an
approved Ground Fault Interrupter (GFI) prior to operation of the pump.
!