page 10 of 73
THE WIRED REMOTE CONTROL
THE WIRED REMOTE CONTROL
The wired remote control is an optional equipment. If you initially ordered the machine without
one, you can order one any time in the future as the electronic controller always features a suitable
connector. From the customer's perspective, this is a plug'n'play device.
The wire remote control can be used to manually control the machine in each axis, turn the
spindle rotations on and off or set the project's starting position. It can also be used to adjust the
spindle rotations and cutting speed during the cutting process. The remote control features a display
which shows the current XYZ co-ordinates (in relation to the project's starting position, not the
machine absolute co-ordinates – please see following sections for details), current spindle rotations
as well as speed.
The remote control buttons' descriptions:
Turn the spindle rotations on
Turn the spindle rotations off
www.megaplot.com phone: +48 693 707 575 office@megaplot.com
ON
OFF
To Next Page
Loading...