27
Setup options
Warning messages
The following warning messages may be displayed during the testing process.
Characters which appear in the aux (small) digit field on the display are shown here in a slightly smaller font size.
Startup warnings
“UNC” -Instrument is un-calibrated
Battery
“bAt” -Low battery
Battery charger
“bAt CHA” -Battery charging
“bAt FUL” -Battery fully charged
Fuse warning
“FUS” -Fuse blown.
Invalid rotary switch setting
“ERR - - -“ -General error – invalid combination of rotary switches.
Continuity test
“VOL 0-L” -Voltage overload during test
Insulation test
“1000 V 1000 V” -Flashing warning before 1 kV test.
“VOL 0-L” -Voltage overload during test
GFCI Test
“trp” -Supply tripped unexpectedly.
“>50V” -Test aborted due to danger of exceeding touch-voltage limit.
“Err con” -Hardware problem detected during High Current Loop test or GFCI test.
GFCI range selection errors
“ERR >1000 mA” -Requested current is >1000 mA.
“ERR - - -“ + Type A -In Type A mode -Instrument has been set for Type A test, but Type A test is not valid
with this setting.
“ERR - - -“ + Type B -In type B mode - Instrument has been set for Type B test, but Type B test is not valid
with this setting.
“ERR - - -“ + Type S breaker symbol
-Instrument has been set for Type S test, but Type S test is not valid with this setting.
“ERR HI mA” -On VAR range, current is set too high for the selected test.
To Next Page
Loading...
Need help?
General
