9625762 24 / 44
15 Settings / modifications / on-site adaptation
15.1 Using the keyboard for programming
Access codes for various user-levels have been defined. Once the complete code has
been entered, the entered code is compared with the internal code table. Depending on
the code entered, the corresponding user level will be accessed. 2 access codes are
available for each user level; the first is for restricted access, i.e. no modification of pa-
rameters is possible (viewing mode), and the second gives access to the entire range of
functions (viewing and modification).
In the short programming instructions accompanying every machine in the series, this is
described in condensed form.
For control programming, the power supply must be available but the machine must be
completely switched off (no LED must be illuminated).
Code – input:
View service data: CODE 10000
Modify service data: CODE 10001
View configuration data: CODE 20000
View dosing technology: CODE 40000
Modify dosing technology: CODE 40044
The code numbers for the further levels can be found in the Service Manual.
Accept /
modify
Increase value/
move forward
Decrease value/
move backwards
Exit
Value field
Function field
To Next Page
Loading...
