9712938 16 / 68
Design and construction subject to change without prior notice!
Information on cleaning the machine
Foam can cause malfunctions in the dishwashing machine and a poor wash.
• Do not use a foaming manual dishwashing detergent for pre-cleaning or for
cleaning the machine.
• Allow machine components to cool down before touching.
Information on cleaning the surrounding area
When cleaning the surrounding area, the machine can be damaged by aggressive
external influences (fumes, cleaning substances) or the ingress of water.
• Do not use aggressive cleaning agents (e.g. aggressive tile cleaner).
• If installed at ground level, never allow the surrounding area to flood.
Information on electricity and electronics
Depending on requirements, the dishwashing machine is to be connected to a sin-
gle-phase (230 V) or a three-phase (400 V) earth wire system. There is a risk of fatal
injury if exposed, electrically charged components or cables are touched.
• Please take note of the warning information in these instructions and the signs
on the dishwashing machine.
• For all work on electrical components in the machine, ensure that the electrical
connections are physically secure.
• For all work on electrical components in the machine, check the wires and ca-
bles for any possible damage and replace, if necessary.
Incorrect cleaning can cause damage to the electronics.
• The dishwashing machine, switch cabinets and other electrical components
must never be sprayed with a hose or high pressure cleaner.
• Make sure that no water can enter the machine unintentionally.
Information on non-ionising radiation
due to electrical operating equipment (e.g. electrical motors, high-voltage cables
and magnetic coils). In addition, the machine has no strong permanent magnet.
4.8 What to do in the event of an emergency
In emergency situations, rapidly switching off the machine will help prevent personal
injury or material damage.
To Next Page
Loading...
Need help?
General
