9712938 23 / 68
Design and construction subject to change without prior notice!
7 Assembly
Warning
Danger of injury due to entry into a danger zone
Unauthorised persons might be in or enter the danger zone during transport, as-
sembly, commissioning, maintenance and repair work. This can lead to injuries.
• Only qualified persons should perform work at and with the machine.
• Remove unauthorised persons from the danger zone.
• Block off danger area and mark it for third parties.
• Never remove or disable safety devices on the machine.
7.1 Prerequisites for assembly
7.1.1 Checking the condition at delivery
• Check that the delivery is complete immediately after receiving it by comparing
it with MEIKO’s order confirmation and/or the delivery note.
• If applicable, submit a claim for any missing parts immediately to the freight for-
warder and notify MEIKO.
• Check the machine for transportation damage.
Note
If there is any suspicion of transportation damage, the shipping company and
MEIKO must be informed immediately in writing. Photograph any damaged parts
7.1.2 Requirements for the installation area
The dishwashing machine is only frost-proof in as-delivered state or if equipped with
special features (optional: frost removal).
Installation of the dishwashing machine in an area where the ambient temperature is
below 0° C can result in damage to the internal water circuit components (e.g.
pump, solenoid valve, boiler, etc.).
• Ensure that the storage and installation locations are always frost free.
There is a danger of slipping in the working area due to the use of water.
• After assembly, put in place non-slip floor coverings in the working area based
on the general/location-specific safety regulations.
To Next Page
Loading...
Need help?
General
