Operating instructions Glass-, dish- and utensilwashing machine
M-iClean U
9712938 61 / 68
Design and construction subject to change without prior notice!
Material damage due to water ingress
Electrical cables and electronic components can be damaged if they come into
contact with water.
• The dishwashing machine, switch cabinets and other electrical components
must never be sprayed with a hose or high pressure cleaner.
• Make sure that no water can enter the machine unintentionally.
• If installed at ground level, never flood the surrounding room.
The machine is emptied, see section see section "Shut down the machine" on
page 50.
2. Remove filter and washing systems.
3. Remove all food residues which are stuck to the tank, the tank heater and the
filters using a brush.
4. Remove the washing and rinse arm and rinse thoroughly under running water.
When doing this, pay particular attention to the nozzles!
Do not use a foaming manual dishwashing detergent for pre-cleaning or for cleaning
the machine. Foam causes malfunctions and can result in a poor wash.
5. To ensure that the sensor detects the rotation of the washing arm, remove all
dirt particles and ferrous particles which are sticking to the magnet (1).
6. Clean the inner chamber of the tank.
7. Inspect the main pump filter for contamination daily and clean as necessary. To
clean, remove the filter and rinse thoroughly under running water.
8. Reinstall all parts.
To Next Page
Loading...
Need help?
General
