Melex 465 - 5.12. Lifting Vehicle to Replace Wheels; Lifting Vehicle for Front Wheel Exchange; Lifting Vehicle for Rear Wheel Exchange

Owners manual MELEX 4XX MELEX 2021/01
43
Model / Tire 20,5x8-10 205/50-10 6PR 195/55R10C 18,5x8,50-8
423, 433, 435 F-150 R-200**
F-150 R-250
F-150 R-200**
F-150 R-250
F-130 R-160
F-130 R-160
443, 445 F-150 R-250**
F-150 R-300
F-150 R-250
**
F-150 R-300
5
T,5
465, 464, 466 F-200 R-250
F-200 R-300
F-200 R-250
F-200 R-300T
-
3,0
F-200 R-450
F-200 R-450
468, 469 F-200 R-250
F-200 R-300
F-200 R-250
F-200 R-300
**- Recommended pressure with load: driver and passenger.
Homologated models
Model / Tire 20,5x8-10 205/50-10 6PR 195/55R10C 18x8,00-10
(195/50 B10)
447 F-150 R-250 F-150 R-250 F-150 R-250
445 F-150 R-300 T,5 F-150 R-300 F-150 R-300
463 F-200 R-300 -3,0 F-200 R-300 F-200 R-300
465 F-200 R-300 F-200 R-300 F-200 R-300
It is necessary to examine the wear of tyre tread. The minimum tread height below
which the tire needs to be replaced is 1.6 mm or the other specified in the regulations in the
place of use.
To replace the wheels in the vehicle, park the vehicle in accordance with the instructions
in the manual (point 5.12) and then raise it with a jack.
ATTENTION
When installing the wheels with directional tires, please pay attention the tyre treads are
positioned properly. The vehicle wheels set (tyre plus rim) should consist of 2 left and 2 right
wheels.
Air pressure in the tire cannot be higher then max allowed by producer, always read
information on the tire.
Take special caution and means of security in case of service and tires control.
5.12 Lifting of vehicle to replace the wheels – support points of jack
Prior to lifting of vehicle it must be immobilized using hand brake and wheel chocks.
Park vehicle on stabile and flat surface.
Lifting of vehicle at exchange of front wheels
Lifting of vehicle is done by support of jack in central point of front axle.