EasyManuals Logo

Melitta Avanza User Manual

Melitta Avanza
Go to English
344 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #43 background imageLoading...
Page #43 background image
Preparing beverages
43
GB
If a coee beverage is not prepared
within 1 minute, the appliance switches
to single-cup dispensing.
5.6 Preparing milk foam
You prepare milk foam on the Cappuccina-
tore. Steam is required for the preparation
of milk foam.
CAUTION
Outowing steam and hot steam pipe
Do not reach into the steam that is
owing out.
Do not touch the steam pipe during
and immediately after use. Wait until
the steam pipe has cooled down.
Requirement: The appliance is ready
for operation. The Cappuccinatore is
connected to the appliance and milk is
connected.
1. Place a vessel beneath the Cappucci-
natore.
2. Press the "Steam dispenser"
button.
» The ashing Steam display indi-
cates that the appliance is heating
up for the steam dispenser.
» Afterwards, the lit Steam display
indicates that the steam dispenser
is ready.
3. Open the "valve".
» Beverage dispensing starts.
4. Close the "valve".
» Beverage dispensing stops.
5. Remove the vessel.
6. Prepare further beverages or rinse the
Cappuccinatore:
a) Prepare further beverages and rinse
the Cappuccinatore later.
b) Rinse the Cappuccinatore as
described below.
Information
After 30 seconds the appliance automati-
cally switches from steam mode to ready
mode. Press the "Steam dispenser", button
to switch to ready mode beforehand.
Rinsing the Cappuccinatore
1. Fill a vessel with clear water.
2. Immerse the milk hose in the lled
vessel.
To ensure that sucient water can be
drawn in, the end of the hose must not
touch the bottom of the vessel.
3. Place an empty vessel beneath the
Cappuccinatore.
4. Press the "Steam dispenser"
button.
» The ashing Steam display indi-
cates that the appliance is heating
up for the steam dispenser.
» Afterwards, the lit Steam display
indicates that the steam dispenser
is ready.
5. Open the "valve".
6. As soon as a clean water/steam
mixture ows into the empty vessel,
close the "valve".
» The Cappuccinatore is rinsed.
Information
We recommend:
Not only rinsing the Cappuccinatore,
but dismantling and cleaning it at reg-
ular intervals (see section7.2 Cleaning
the Cappuccinatore on page48).
Rinsing the Cappuccinatore each week
with the Melitta® PERFECT CLEAN
milk system cleaning agent for fully
automatic coee makers. Use the milk
system cleaning solution instead of
fresh water.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Melitta Avanza and is the answer not in the manual?

Melitta Avanza Specifications

General IconGeneral
Weight7.5 kg
Water Tank Capacity1.5 L
Bean Container Capacity250 g
Pump Pressure15 bar
Power1450 W
Milk FrotherYes
Adjustable Coffee StrengthYes
Adjustable Coffee SpoutYes
Voltage220-240 V
Grinder TypeSteel Cone Grinder
Adjustable Grinding DegreeYes
Adjustable Water AmountYes
Height-Adjustable Coffee OutletYes
Automatic Shut-OffYes
Cleaning ProgramYes
Descaling ProgramYes
TypeAutomatic Coffee Machine
Number of Cups2

Related product manuals