Care and maintenance
49
GB
1. Open the cover (11). To do this, reach
into the recess on the right of the appli-
ance and pull the cover o sideways.
2. Press and hold the red lever(30) on the
brewing unit handle(12) and turn the
handle clockwise until it engages at the
stop.
3. Pull the brewing unit out of the appli-
ance by the handle.
4. Rinse the entire brewing unit thor-
oughly from all sides under running
water. In particular, make sure that
coee residues are removed from the
sieve(31).
5. Allow the brewing unit to drip dry.
6. Use a soft, dry cloth to remove coee
residues from the surfaces inside the
appliance.
7. Insert the brewing unit into the appli-
ance. Press and hold the red lever on
the handle of the brewing unit and
turn the handle anticlockwise until it
engages at the stop.
8. To do this, insert the cover sideways
until it engages.
When the appliance is switched on, an
alternating ashing of the Ready display
and the Clean display indicates a missing
brewing unit. After the brewing unit has
been inserted, the appliance switches to
Ready mode.
7.4 Running the cleaning
programme
This cleaning programme is used to
remove residues and coee oil residues
with the aid of fully automatic coee
maker cleaning agents.
To avoid damage to the appliance, we
recommend running the cleaning pro-
gramme every 2 months or as requested
by the appliance.
The Clean display light requests
you to clean the unit.
CAUTION
Contact with fully automatic coee
maker cleaning agent may lead to eye
and skin irritation.
Observe the processing instructions on
the packaging of the fully automatic
coee maker cleaning agent.
ATTENTION
The use of unsuitable fully automatic
coee maker cleaning agent can damage
the appliance.
Only use Melitta® PERFECT CLEAN
cleaning tablets for fully automatic
coee machines.
The cleaning programme takes approx.
15minutes and should not be interrupted.
The cleaning programme runs in several
stages. Progress is indicated by the num-
ber of coee beans displayed.
The appliance performs several rinsing
operations during the cleaning pro-
gramme. The drip tray is also rinsed.
Requirement: The appliance is ready for
operation.
1. Press the "Service" button for
more than 2seconds to call up Service
mode1.
2. Press the "Service" button
repeatedly until the display for the
cleaning programme appears.
3. Press the "Service" button for
more than 2seconds to start the
cleaning programme.
» The Clean display ashes
until the cleaning programme is
nished.
The rst stage of the cleaning pro-
gramme starts. One coee bean lights up.
» The Drip tray display lights
up and requests you to empty the
drip tray and the coee grounds
container.
To Next Page
Loading...
Need help?
General
