Melitta Avanza - Preparing Hot Water; Changing Basic Settings

Changing basic settings
44
GB
5.7 Preparing hot water
You prepare hot water on the Cappucci-
natore.
CAUTION
Hot water and hot steam owing out of
the pipe
 Do not reach into the hot water that is
owing out.
 Do not touch the steam pipe during
and immediately after use. Wait until
the steam pipe has cooled down.
Requirement: The appliance is ready for
operation. The Cappuccinatore is con-
nected.
1. Place a vessel beneath the Cappucci-
natore.
2. Open the "valve".
» Beverage dispensing starts.
3. Close the "valve".
» Beverage dispensing stops.
4. Remove the vessel.
6 Changing basic settings
You can change the basic settings of the
appliance with several functions. The func-
tions are divided into two service modes.
6.1 Service mode 1
Each function is assigned a display.
Service mode 1
Display function
Auto OFF
Water hardness
Switch-o rinsing
Filter programme
Cleaning programme
Service mode 1
Display function
Descaling programme
Brewing temperature
To call up Service mode1, proceed as
follows:
Requirement: The appliance is ready for
operation.
1. Press the "Service" button for
more than 2seconds to call up Service
mode1.
»  The Ready display ashes rap-
idly and the 2 cups button lights up.
2. Press the "Service" button one or
more times to access the desired
function.
» A display lights up according to the
function selected, see Service mode1
table.
» The number of lit bean symbols
indicates the current setting of the
function.
Press the "Coee" direct key to exit the
service mode without saving the settings.
Information
If no further input is made within 1min-
ute, the appliance returns to Ready mode.
6.2 Setting Auto OFF
If you do not operate the machine for a
long time, it initially switches to energy
save mode. After a further preset time, the
appliance switches o.
The following settings are possible:
Display Energy save
mode after:
Switch o after:
3 minutes 30 minutes

10 minutes 1 hour
 
20 minutes 4 hours