Melitta CI TOUCH F630-101 User Manual

Basic operation
35
GB
and other objects. The space above the
appliance should be at least 20cm.
ū Route the power cable so it cannot be
damaged by edges or hot surfaces.
3.4 Connecting the appliance
Observe the following instructions:
ū Check that the supply voltage matches
the operating voltage specied in
the technical data (see section11,
page51).
ū Only connect the appliance to a prop-
erly installed earthing contact socket. If
in doubt, consult a specialist electrician.
ū The socket must have a fuse of at least
10 A.
3.5 Switching on the appliance
for the rst time
During initial start-up, the language, the
time and the water hardness can be set.
The settings can be changed at a later
point in time (see chapter8, page43
and section9.8, page49).
Use the enclosed test strip to determine
the water hardness. Observe the instruc-
tions on the test strip packaging and the
table in section11, page51.
Information
We recommend pouring away the rst two
cups of coee after initial start-up.
Requirement: The appliance has been
installed and connected.
1. Place a vessel beneath the outlet.
2. Switch on the appliance with the ON/
OFF button.
» The welcome display appears on the
appliance.
» The request to carry out setup
appears on the display: Please set up
the machine.
3. Conrm setup with the "rotary switch".
» The Language menu appears.
4. Select your language with the "rotary
switch". Conrm your selection.
» The Clock menu appears.
5. Select the hour and the minutes with
the "rotary switch". Conrm your
settings.
» The Water hardness menu appears.
6. Select the determined water hardness
range with the "rotary switch" or con-
rm the default value.
» The request Please rell and insert
water tank appears.
7. Remove the water tank. Rinse out the
water tank with clean water. Insert the
new water lter (see section „Switching
on the appliance“ on page 36).
Fill the water tank with fresh water and
insert it.
» The appliance heats up and per-
forms automatic rinsing.
» The ready symbol and the request
Fill beans appear on the display.
8. Fill coee beans into the bean con-
tainer. To do this, read section4.4,
page37.
4 Basic operation
This chapter describes basic operating
steps for using the appliance on a daily
basis.
4.1 Switching the appliance on
and o
Before switching on after starting up the
appliance for the rst time, read sec-
tion3.5.
Information
ū When switched on and o, the appli-
ance performs automatic rinsing.
ū During rinsing, rinsing water is also
conducted into the drip tray.
ū The automatic switch-o rinsing can be
switched on or o in the Settings menu.

Melitta CI TOUCH F630-101 Specifications

General

Brand	Melitta
Model	CI TOUCH F630-101
Category	Coffee Maker
Language	English