Melitta CI TOUCH F630-101 - Descaling programme; Setting the water hardness; Using a water filter

Care and maintenance
49
GB
Requirements:
ū The appliance is ready for operation.
ū A container (0.7l) is placed beneath the
spout.
1. Press the "rotary switch" for 2 seconds.
» The menu appears on the display.
2. Navigate to the Care > Descaling menu.
3. Select Start and conrm your selection.
4. Follow the further instructions on the
display up to the end of the descaling
programme.
9.8 Setting the water hardness
The set water hardness inuences the fre-
quency of descaling. The harder the water,
the more frequently the appliance has to
be descaled.
Information
The water hardness cannot be set if you
use a water lter.
Determine the water hardness with the
enclosed test strip. Observe the instruc-
tions on the test strip packaging and
table11, page51.
Requirement: The appliance is ready for
operation.
1. Press the "rotary switch" for 2 seconds.
» The menu appears on the display.
2. Navigate to the
Settings > Water hardness menu.
3. Select the water hardness range and
conrm your selection.
9.9 Using a water lter
The use of a water lter extends the ser-
vice life of the appliance and the appliance
has to be descaled less frequently. The
water lter contained in the scope of deliv-
ery lters calcium and other pollutants out
of the water.
1
37
38
39
Fig. 18: Screwing/unscrewing the water
lter
The water lter(38) is screwed into and
unscrewed from the thread(37) on the
base of the water tank(39) using the
screwing aid at the end of the enclosed
coee spoon(1).
Inserting the water lter
Information
Place the water lter into a vessel lled
with fresh tap water for a few minutes
before inserting it.
Requirements:
ū The appliance is ready for operation.
ū A container (0.7l) is placed beneath the
spout.
1. Press the "rotary switch" for 2 seconds.
» The menu appears on the display.
2. Navigate to the Care > Filter > Insert
lter menu.
3. Select Start and conrm your selection.
4. Follow the further instructions on the
display.
» The water hardness is automatically
adjusted on the water lter by the
appliance.
» The appliance is ready for operation.