Permanently changing beverage settings
41
GB
Changing beverage settings during
preparation
The beverage quantity and the coee
strength can be changed during beverage
preparation.
Requirement: The appliance is ready for
operation.
During beverage dispensing (coee
or milk), use the "rotary switch" to
set the respective beverage quantity.
During the grinding process, use the
"Coee strength" button to set the
coee strength.
5.7 Stopping beverage
preparation
To stop beverage preparation prematurely,
press the selected direct key again.
5.8 Preparing two beverages
simultaneously
The "2 cups" button is used to pre-
pare two beverages.
Information
Two-cup dispensing is not possible for
beverages mixed with hot water (amer-
icano), for milk froth, warm milk or hot
water.
8
26
Fig. 11: Two-cup dispensing
1. Place two vessels beneath the out-
let(8).
2. Press the "2 cups"button (26).
3. Continue as described for the relevant
beverage preparation.
Information
ū This setting only applies to the next
beverage preparation.
ū If a beverage is not prepared within
1 minute, the appliance switches to
single-cup dispensing.
6 Permanently changing
beverage settings
The appliance oers further options for
preparing coee specialities.
6.1 Changing default settings
Depending on the beverage, the following
default settings can be changed:
Coee amount, amount of froth, milk
amount, hot water amount, coee
strength and temperature.
Changing the beverage settings is similar
for all beverages. Changing the coee
strength for an Espresso is described here
as an example.
1. Press the "rotary switch" for 2 seconds.
» The menu appears on the display.
2. Navigate to the
Direct keys > Espresso > Coee strength
menu.
3. Select the desired coee strength and
conrm your selection.
4. Select the Exit command to exit the
menu.
» The selected coee strength is used the
next time an espresso is prepared.
Information
The default settings remain valid until they
are changed again.
To Next Page
Loading...
Need help?
General
