EasyManuals Logo

Memotec mychron 3 User Manual

Memotec mychron 3
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #29 background image
Spark for
Revs
This option represents the number of spark signals for every
engine revolution. A two-stroke engine has one spark signal per
revolution, while a four-stroke engine has a spark every two
engine revolutions.
To set the Spark for Revs, after having entered the
CONFIGURATION MODE, push MENU/<< till when you don’t
see
SPARK FOR REVS
Then push MEM to enter EDIT MODE and use buttons
MENU/<< or >> to scroll between three standard values: x1, x2
and /2. For a two-stroke, one cylinder engine, the RPM ratio is
x1.
Press button MEM to save the changes or button VIEW to
discard the changes.
Temperature
measure unit
This function sets the temperature’s measure unit; the user can
choose between Celsius [°C] or Fahrenheit [°F] degrees.
To run this function, after having entered the CONFIGURATION
MODE, push MENU/<< till when you don’t see
FAHRENHEIT/CELSIUS
Then push MEM to enter EDIT MODE and use button
MENU/<< till you don’t see the proper Temperature unit of
measure, and confirm it pushing MEM. Press button VIEW to
discard the changes.
The symbols °C or °F will appear on the left of the display.
28

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Memotec mychron 3 and is the answer not in the manual?

Memotec mychron 3 Specifications

General IconGeneral
BrandMemotec
Modelmychron 3
CategoryMeasuring Instruments
LanguageEnglish