SDM-9XXX Series Hardware Installation Guide
5-6 Memotec Inc.
5.5 Custom Serial Cable Specifications
In the following sections the Ordering part number is required for ordering extra cables.
The Stock number is printed on the cable.
5.5.1 V.35/V.11 Cables
• HD-26 male connector at one end for connection to the NetPerformer serial port
• ISO-2593 female (DCE) or male (DTE) connector at the other end for connection
to the V.35/V.11 equipment
- Use the DCE cable for connection to a male connector on the V.35/V.11
equipment (typically a DTE device)
Ordering part number 161-0893-001, Stock number 502-0940-006.
- Use the DTE cable for connection to a female connector on the V.35/V.11
equipment (typically a DCE device).
Ordering part number 161-0894-001, Stock number 502-0941-006.
5.5.2 TIA-232 (V.24) Cables
• HD-26 male connector at one end for connection to the NetPerformer serial port
• DB-25 female (DCE) or male (DTE) connector at the other end for connection to
the TIA-232 (V.24) equipment
- Use the DCE female cable for connection to a male connector on the TIA-232
(V.24) equipment (typically a DTE device)
Ordering part number 161-0897-001, Stock number 502-0944-006.
- Use the DTE male cable for connection to a female connector on the TIA-232
(V.24) equipment (typically a DCE device)
Ordering part number 161-0898-001, Stock number 502-0945-006.
5.5.3 X.21 Cables
An X.21 cable has a 4-40 screw on the DB-15 connector.
• HD-26 male connector at one end for connection to the NetPerformer serial port
• DB-15 female (DCE) or male (DTE) connector at the other end for connection to
the X.21 equipment
- Use the DCE female cable for connection to a male connector on the X.21
equipment (typically a DTE device)
Ordering part number 161-0895-001, Stock number 502-0942-006.
- Use the DTE male cable for connection to a female connector on the X.21
equipment (typically a DCE device)
To Next Page
Loading...
Need help?
General
