SDM-9XXX Series Hardware Installation Guide
4-12 Memotec Inc.
smaller screws are to attach the optional handle to the bracket.
3. Optionally, you can add a handle to the bracket by aligning the handle with the holes
and attaching the handle using 2 screws provided.
4. Using the mounting screws, secure each mounting bracket on either side of the unit
along the front edge. Secure the bracket to the side of the device with 3 screws, using
the 3 holes closest to the front of the bracket. See Figure 4-6.
5. Insert the unit into the rack at the desired level and line the holes in the unit mounting
SDM-9120 brackets with the holes in the rack mounting plates.
6. Once the unit is in position, tighten all the rack mounting screws.
Figure 4-5: Mounting screws and mounting bracket
Figure 4-6: Side view of a unit with bracket
Tip
The unit can be more easily mounted if support screws are installed
halfway
just below the bottom of the unit's final resting position in the
rack. The mounting brackets now have a place to rest during the
installation process.
Rack
mounting
hole
Mounting
holes on
bracket to unit
Mounting holes
on unit
To Next Page
Loading...
Need help?
General
