EasyManuals Logo

Memotec NetPerformer SDM-9120 Series User Manual

Default Icon
138 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #124 background imageLoading...
Page #124 background image
SDM-9XXX Series Hardware Installation Guide
B-10 Memotec Inc.
EN55032 and CISPR32 Warning
The SDM-9120 is a Class A product that may cause radio interference.
In this case the user may be required to take adequate measures
EN55032 and CISPR32 Statement
The SDM-9220 and the SDM-9230 are Class B products.
FCC Part 15 Statement
The SDM-9120 has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference, in
which case the user will be required to correct the interference at his or her own expense.
The SDM-9220 and SDM-9230 have been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
The SDM-9220/9230 with
Interface Cards P/N 100-
1092-002 or -502 (Quad
E&M). The SDM-9120 with
Interface card 100-1092-
502A
This telecom Equipment is intended to be connected to the
following telecom services:
• 2-wire Analog access to Leased Circuits in all the countries
listed below
• 4-wire Analog access to Leased Circuits in all the countries
listed below
List of countries: Austria, Belgium, Bulgaria, Czech Republic,
Cyprus, Denmark, Estonia, Finland, France, Germany,
Greece, Hungary, Iceland, Republic of Ireland, Italy, Latvia,
Lithuania, Luxemburg, Malta, Netherlands, Norway, Poland,
Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Swit-
zerland, UK.
Item Compatible Telecom Services
Table 0-1 Compatible Telecom Services

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Memotec NetPerformer SDM-9120 Series and is the answer not in the manual?

Memotec NetPerformer SDM-9120 Series Specifications

General IconGeneral
BrandMemotec
ModelNetPerformer SDM-9120 Series
CategoryNetwork Hardware
LanguageEnglish

Related product manuals